6073PPE36

Round moulding 22x44x3600 half-round

Product category
Round mouldings
Material
Pine
Treatment
Planed
Color
Thickness × Width
22 mm × 44 mm
Length
3600 mm
EAN
6438202017726

Intended use

For dry indoor spaces.

Preparation of the installation work

  • Products should be stored indoors in a dry place, protected from rain and sunlight.
  • Before installation, stack the products loosely and let them sit for approximately one week to allow their temperature and humidity become level with the surrounding conditions.
  • The room temperature and humidity at the installation site should be normal (temperature approx. 20 °C and humidity below 50%).

Installing round mouldings

  • Make sure that the lighting is sufficient during installation.
  • Depending on the installation location, secure the mouldings or strips using a finish nailer, mounting adhesive or screws.
  • When using screws to secure the product, you will need to pre-perforate the product to prevent it from cracking.
  • Fasten the product every 60 cm.
  • Press the product firmly against the mounting surface before securing it.

DO NOT INSTALL A DEFECTIVE PRODUCT. ONCE INSTALLED, A PRODUCT IS CONSIDERED APPROVED.